DNKa’ Gel Paint Ethno

Decorative Gel Paint — High Pigment, Thick Consistency, No Sticky Layer
The gel paint collection consists of 3 highly pigmented dense shades without a residual sticky layer:

• White -  medium thickness
• Black - thick
• Red -  medium thickness

This collection allows you to create thin, color-saturated design elements such as geometry, scrolls, ethnic ornaments, brush strokes, stamping, and any other creative ideas.
The gel paint can be applied under the top coat or on top of the finished top coat, which makes it possible to achieve a subtle textured effect on the nail surface.

• Does not run, holds brush strokes and lines, allowing work on several nails simultaneously.
• Not suitable for creating volumetric, relief elements.
• In ultra-thin, semi-transparent layers (such as “fingerprint” design), a top coat is required for sealing.
• To adjust the consistency of the black paint to a medium thickness, it can be mixed with a small amount of Ultra Black Gel Polish.
• This is an alkaline-based cuticle remover used to quickly soften and effectively remove dead skin around the nail plate. Alkaline removers are more powerful than acid or urea-based products, so they are used with proper exposure time and mandatory neutralization.

Main purpose of the product:
Softening the cuticle for subsequent removal during a manicure (trimmed, combined or hardware).
Suitable for professional use, as it acts quickly.

Recommendations for use:

1. Apply the product in a thin layer on the cuticle.
2. Leave on the skin for up to 1 minute 
3. Carefully push back the cuticle with a pusher or orange stick, and treat the skin with the necessary tool.
4. Thoroughly rinse off any remaining product with water to neutralize the alkali.
5. Apply moisturizer or cuticle oil to prevent skin from drying out.

If you want to create a design under the top coat:

1. Remove the sticky layer from the gel polish coating using Nail Prep & Cleanser 3-in-1.
2. Apply the chosen pattern with Ethno Gel Paints, then polymerize in an LED/UV lamp 48/36 W for 120/180 seconds.
3. Seal the finished design with the selected DNKa’ Top, polymerizing for the time recommended for that specific top.

If you want to work on the finished surface:

1. Cover the gel polish with your chosen DNKa’ Top and polymerize according to the instructions for that top.
2. Using Ethno Gel Paints and DNKa’ brushes #001, #002, #003, create the desired design.
3. Polymerize in an LED/UV lamp 48/36 W for 120/180 seconds.
    

Removal: File off.